Charging with the included wall charger
Rhino Motion comes with a wall charger (100-240V input, 13.5V output, 1.33A), which you plug in to charge Motion's battery or to use Rhino Motion without depleting the battery.
Using the included charger, Rhino Motion charges fully in about 3 hours. Under normal operation the battery will last about 7 hours. If you enable power saving mode in Settings, you can get up to 24 hours of battery in Advanced time Lapse.
Using with an external battery or charger
You can use external batteries or chargers to run Rhino Motion.
Note: When using a lower voltage than 13.5V, the battery will not charge to its full capacity. Do not use a higher voltage than 13.5V, as it will damage the battery and/or cause system failure.
Rhino Motion charges with a standard 2.1 mm barrel connector. Here are a some recommended accessories to charge Rhino Motion with: